72 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 57. Installing the UPS Single-string Battery Trays for 5.0 kVA BladeUPS
5. Reinstall the battery cover plate.
6. Install the UPS front cover:
Plug the LCD cable from the control panel on the front cover into the connector on the electronics module.
Use care to loop the LCD cable gently in front of the electronics module.
Push the top of the front cover firmly into place, and then push the bottom firmly into place.
Figure 58. Installing the UPS Front Cover
7. Parallel system only. Repeat the steps starting at the beginning of section for UPS Setup for each UPS to
be paralleled.
8. If installing optional EBM(s), see section 3.13 “EBM Installation” .
Otherwise, continue to section 4.12“Standalone UPS Installation” or section 4.16”Parallel UPS
Installation” .
Installing The UPS Internal Batteries
To Next Page
Loading...
