Eaton CEAG CG-Controller - CG-Controller Setup Menu; Language Selection; Time and Date Settings

21
Manual CEAG CG-Controller for CG 2000/ZB-S 30080001458 (C) July 2016 www.ceag.de
9 Menus
9.8.2 Time and date
9.8.2.1 Switching to daylight savings time
You can switch to daylight savings time by pressing the 7 key in
the «Time and date» submenu item.
The hour is increased by 1. 7 key = PQRS S = Daylight savings
time.
9.8.2.2 Switching back to standard time
You can switch back to standard time by pressing the 9 key in
the «Time and date» submenu item.
The hour is decreased by 1. 9 key = WXYZ W = Standard time.
9.8 «Setup CG-Controller» menu
Line Selection (main menu)
1 Test menu
2 Block, reset
3 Info device
4 Setup CG-Controller ∕
5 Setup device
9.8.1 Select language
Operation:
 Flashing cursor = current
cursor position/selection
Menu Back to the main screen
 Cursor position lower
 Cursor position higher
 Select menu item (Enter)
Line Selection (submenu)
1 Select language ∕
2 Setup time and date
3 Next functiontest
4 Next durationtest
5 Relay settings
6 Serial number
7 Password
8 Contr.cong.→SD
9 Contr.cong.←SD
10 Logbook
11 NID receive
12 Network Master
Operation:
Menu Accept language
 / Language selection
(by selecting the line)
 Accept language
Operation:
Menu Accept settings and
one menu level higher
 /  Insertion pointer
(cursor) left/right
 / Reduce/increase value
 Accept and
one menu level higher
Line Selection (submenu)
1 Select language
2 Setup time and date ∕
3 Next functiontest
4 Next durationtest
5 Relay settings
6 etc.
Line Display
1 Time and date
2 14:15 13.09.2002
3 Change   
4  = Accept
Line Display
1 Sprache : deutsch 
2 Language:English
3
4