6 Parameters
6.4 Setpoint input (REF)
140 DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com
3 Press the Start button to start the frequency inverter.
It will then run with the acceleration time set in P-03 all the way
to the setpoint value on the keypad.
You can use the ▲ and ▼ arrow buttons to change the setpoint
value in RUN mode.
4
Pressing the Start pushbutton again will change the operating
direction (P-12 = 2).
Note:
When the REV operating direction is in effect, the frequency will
have a minus sign.
FWD
REV
Minus sign for REV operating direction
5
When the Stop pushbutton is pressed, the frequency inverter
will be stopped with the deceleration time configured in P-04.
Sequ-e
nce
Commands Indicator
Description
To Next Page
Loading...
