2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
101
TRSM0950 Disassembly/Assembly | Input Shaft Disassembly/Assembly
Input Shaft Disassembly/Assembly
Special Instructions
A press is required for the removal and installation of the
Input Shaft. Failure to use a press results in Input Shaft
and/or Clutch Housing damage.
Note: Clutch Housing is approximately 558 mm (22 inches)
wide. If the Clutch Housing is too large for the available
press, go to
“Input Shaft Disassembly/Assembly using
Input Shaft Press (RR1085TR)” on page 221.
Special Tools
• Input Shaft Cup (RR1087TR-6)
• Input Shaft Stand (RR1073TR)
• Input Shaft Bearing Removal and Installation Tool
(RR1075TR)
• Universal Driver Handle (OE8044-T0)
Note: Universal Driver Handle OE8044-T0 is part of
Overhaul Tool Kit (RR2012TR) and may have already
been purchased to support prior transmission models.
Component Identification
1. Input Shaft Assembly
2. Clutch Housing
3. Input Shaft Bearing
4. Input Shaft Snap Ring
1
2
3
4
To Next Page
Loading...
