Eaton Endurant - Rear Bearing Cover Installation

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
137
noitallatsnI0590MSRT | Rear Bearing Cover Installation
Rear Bearing Cover Installation
Special Instructions
None
Special Tools
• Gasket Sealant (Loctite 5188)
• Gasket Remover (Loctite SF 7631)
Component Identification
1. Output Shaft
2. Thrust Washer
3. O-Ring
4. Rear Bearing Cover
5. Wear Sleeve and Dust Cover
6. Cap Screws (x8) - 13 mm