Eaton Endurant - Torque Specifications

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
235
TRSM0950 Appendix | Inspection Precautions
Torque Specifications
Description Torque
TCM cover nuts - 13 mm (x4) 8.8 - 10.4 Nm
(6-8 lb-ft)
74-Way Connector to TCM jack-
screw - 7 mm (x1)
2 - 2.5 Nm
(2-3 lb-in)
MTM to Main Housing cap screws -
15 mm (x2), 13 mm (x18)
44.5 - 51.5 Nm
(33-38 lb-ft)
LCA to MTM cap screws - T45 Torx 23 - 28 Nm
(17-21 lb-ft)
Output Yoke retainer cap screw - 27
mm (x1)
617 - 690 Nm
(455-508 lb-ft)
Oil Fill Plug - 6 mm Hex (x1) 24.5 - 29.5 Nm
(18-22 lb-ft)
Oil Check Plug - 6 mm Hex (x1) 24.5 - 29.5 Nm
(18-22 lb-ft)
Oil Drain Plug - 6 mm Hex (x1) 24.5 - 29.5 Nm
(18-22 lb-ft)
Rear Bearing Cover to Rear Housing
cap screws - 13 mm (x8)
21 - 25 Nm
(16-19 lb-ft)
Front Upper Countershaft Cover to
Clutch Housing - 13 mm (x6)
21 - 25 Nm
(16-19 lb-ft)
Input Shaft Cover to Clutch Housing
- 13 mm (x7)
21 - 25 Nm
(16-19 lb-ft)
Inertia Brake Cover to Clutch Hous-
ing - 13 mm (x6)
21 - 25 Nm
(16-19 lb-ft)
Rear Housing to Main Housing cap
screws - 16 mm (x22)
44.5 - 51.5 Nm
(33-38 lb-ft)
PTO Cover to Main Housing cap
screws - 18 mm (x8)
69 - 81 Nm
(51-60 lb-ft)
Main Housing to Clutch Housing cap
screws - 16 mm (x25)
44.5 - 51.5 Nm
(33-38 lb-ft)
Output Speed Sensor to Rear Hous-
ing cap screws - 10 mm (x1)
8.8 - 10.4 Nm
(6-8 lb-ft)
Fluid Pressure Sensor (FPS) - 24
mm Hex (x1)
26 - 30 Nm
(19-22 lb-ft)
Clutch to flywheel cap screws - 15
mm (x12)
53.5 - 67.7 Nm
(40-50 lb-ft)
8 Bolt PTO Cover to Main Housing
Cap Screws - 18 mm (x8)
69 - 81 Nm
(51 - 60 lb-ft)
Rear Housing to Main Case Stubbed
Cap Screws - 16 mm (x3)
44 - 51 Nm
(33-38 lb-ft)
Rear Housing to Main Case Cap
Screw - 16 mm (x21)
44 - 51 Nm
(33-38 lb-ft)
Main Housing to Clutch Housing
Cap Screws - 16mm (x25)
44 -51 Nm
(33-38 lb-ft)
Upper Lube Tube Cap Screw - 8 mm
(x1)
8 - 10 Nm
(6-13 lb-ft)
Lower Lube Tube Cap Screw - 8 mm
(x1)
8 - 10 Nm
(6-13 lb-ft)
Rail E Detent Plug - Zero Leak -
6mm Hex (x1)
24 - 29 Nm
(18-21 lb-ft)
Oil Pump Assembly to Main Housing
Cap Screws - 13 mm (x8)
21 - 23 Nm
(16-18 lb-ft)
Reaction Plate Mounting Cap
Screws - 13 mm (x4)
21 - 25 Nm
(16-19 lb-ft)
Release Yoke Pivot Pin - 30 mm (x1) 130 - 140 Nm
(95-101 lb-ft)
4 Bolt Rear Mount PTO Cover to
Rear Housing - 18 mm (x4)
69 - 81 Nm
(51-60 lb-ft)
Rear Housing Lube Tube to Rear
Housing (Dual PTO Transmission
Only) - 8 mm (x1)
8.8 - 10.4 Nm
(6-8 lb-ft)
Lifting Eye Bracket Mounting Cap
Screws - 15 mm (x4)
49.6 - 55.5 Nm
(36-40 lb-ft)
Rear Speed Sensor Bracket Cap
Screws - 10 mm (x3)
8.8 - 10.4 Nm
(6-9 lb-ft)
Description Torque