130
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Clutch Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure - Disassembly
1. Ensure Input Shaft Snap Ring is removed.
2. Place Clutch Housing in press with Input Shaft up.
CAUTION: Clutch Housing weighs approximately 50
lbs. Keep fingers clear of pinch points between Clutch
Housing and other surfaces. Dropping Clutch Housing
could result in component damage and/or personal
injury.
NOTICE: A press is required for the removal and instal-
lation of the Input Shaft. Failure to use a press results
in Input Shaft and/or Clutch Housing damage.
NOTICE: Support the Clutch Housing to avoid damag-
ing the housing and sealing surface.
Note: Clutch Housing is approximately 558 mm (22
inches) wide. If the Clutch Housing is too large for the
available press, go to
“Input Shaft Disassem-
bly/Assembly using Input Shaft Press (RR1085TR)” on
page 221.
3. Place Input Shaft Cup (RR1087TR-6) on the end of the
Input Shaft.
4. Press Input Shaft from Clutch Housing.
5. Mark Clutch Housing case to indicate airline inlet direc-
tion with a paint mark.
To Next Page
Loading...
