2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
205
TRSM0950 Installation | Clutch Installation
Clutch Installation
Special Instructions
Install Clutch Alignment Shaft (RR1087TR) onto a clutch
jack. Refer to clutch jack manufacturer guidelines for
proper installation instructions.
WARNING: Clutch weighs approximately 125 lbs. Failure to
properly secure the Clutch Alignment Shaft to the clutch
jack may result in clutch damage, severe injury or death.
Special Tools
• Clutch Installation Tool Kit (RR2000CL)
• 6 ounce (170 gram) hammer
• 3/8 inch (9.525 mm) brass pin punch (Starrett®
B248E Pin Punch, Brass Drive 3/8" or equivalent)
Component Identification
1. Clutch Cover Cap Screws (x12) (M10 x 1.5 x 80mm, minimum class 10.9, flange type fasteners)
2. Clutch Cover
3. Driven Disc Assembly
4. Alignment Pins (x2)
5. Engine Flywheel
To Next Page
Loading...
