2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
219
TRSM0950 Appendix | Manually Vent Linear Clutch Actuator (LCA)
Manually Vent Linear Clutch Actuator (LCA)
1. Key off.
2. Set vehicle parking brake and chock wheels.
WARNING: Apply vehicle parking brake and follow
vehicle manufacture parking instructions. Failure to follow
these instructions could cause unintended vehicle move
-
ment and may result in major vehicle component damage,
severe injury of death.
3. Loosen the 4 Linear Clutch Actuator (LCA) cap
screws 1-2 turns each with a T45 Torx.
Note: Residual air pressure in the LCA cylinder
exhausts between the LCA and Mechatronic Transmis
-
sion Module (MTM) housing when the cap screws are
loosened.
4. Tighten the 4 LCA to MTM T45 cap screws and
torque to 23-27 Nm (17-21 lb-ft).
To Next Page
Loading...
