Eaton Endurant - 2018 Eaton Cummins Automated Transmission Technologies. All Rights Reserved

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
131
TRSM0950 Disassembly/Assembly | Clutch Housing Disassembly/Assembly
6. Remove Inertia Brake 90-degree airline elbow (15
mm).
7. Remove the Release Yoke Pivot Pin (30 mm).
8. Place Clutch Housing in press with flywheel housing
side of the Clutch Housing down.
NOTICE: Support the Clutch Housing to avoid damag-
ing the housing.
9. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR) and Universal Driver Handle
(OE8044-T0) onto Input Bearing.
10. Press Input Shaft Bearing from Clutch Housing.
11. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Lower
Countershaft Bearing.
12. Press Lower Countershaft Bearing from Clutch Hous-
ing.