2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
133
TRSM0950 Disassembly/Assembly | Clutch Housing Disassembly/Assembly
Procedure - Assembly
CAUTION: Clutch Housing (without Input Shaft) weighs
approximately 40 lbs. Keep fingers clear of pinch point
between Clutch Housing and other surfaces. Dropping
Clutch Housing could result in component damage and/or
personal injury.
1. Place Clutch Housing in press with flywheel housing
side up.
2. Place Upper Countershaft Bearing into Clutch Housing.
3. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Upper
Countershaft Bearing.
4. Press Upper Countershaft Bearing into Clutch Housing.
NOTICE: Do not over press bearing into Clutch Hous-
ing. Over pressing could result in component damage.
5. Verify Upper Countershaft Bearing is fully seated in
Clutch Housing.
6. Place Lower Countershaft Bearing into Clutch Housing.
7. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Lower
Countershaft Bearing.
8. Press Lower Countershaft Bearing into Clutch Housing.
NOTICE: Do not over press bearing into Clutch Hous-
ing. Over pressing could result in component damage.
9. Verify Lower Countershaft Bearing is fully seated in
Clutch Housing.
To Next Page
Loading...
