Eaton Endurant - Installation; Rear Bearing Cover Installation

134
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Clutch Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
10. Place Input Shaft Bearing into Clutch Housing.
11. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR) and Universal Driver Handle
(OE8044-T0) onto Input Shaft Bearing.
12. Press Input Shaft Bearing into Clutch Housing until
fully seated.
NOTICE: Do not over press bearing into Clutch Hous-
ing. Over pressing could result in component damage.
13. Verify Input Shaft Bearing is fully seated in Clutch
Housing.
14. Install Front Bearing Capture Plate (RR1085TR-7) to
the Clutch Housing using the Input Shaft Cover
threaded mounting holes and hand tighten 4 plate cap
screws with a 6 mm hex key.
15. Torque cap screws to 21-25 Nm (16-19 lb-ft) in a
criss-cross pattern.
16. Place Clutch Housing in press with flywheel housing
side of the Clutch Housing down.
NOTICE: Support the Clutch Housing to avoid damag-
ing the housing.
17. Install Input Shaft into Clutch Housing.