Eaton Endurant - Clutch Removal

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
19
TRSM0950 Removal | Clutch Removal
Clutch Removal
Special Instructions
Install Clutch Alignment Shaft (RR1087TR) onto a clutch
jack. Refer to clutch jack manufacturer guidelines for
proper installation instructions.
WARNING: Clutch weighs approximately 125 lbs. Failure to
properly secure the Clutch Alignment Shaft to the clutch
jack may result in clutch damage, severe injury or death.
Special Tools
• Clutch Installation Tool Kit (RR2000CL)
Component Identification
!
1. Clutch Cover Cap Screws (x12) - 15 mm
2. Clutch Cover
3. Driven Disc Assembly
4. Engine Flywheel
1
2
3
4