Eaton Endurant - 2018 Eaton Cummins Automated Transmission Technologies. All Rights Reserved

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
135
TRSM0950 Disassembly/Assembly | Clutch Housing Disassembly/Assembly
18. Place Input Shaft Cup (RR1087TR-6) on the Input
Shaft.
19. Press Input Shaft into Input Bearing until full seated.
NOTICE: Do not over press Input Shaft into Clutch
Housing. Over pressing could result in component
damage.
20. Remove Front Bearing Capture Plate (RR1085TR-7).
21. Install Input Shaft Snap Ring.
NOTICE: A new snap ring is required when reinstalling.
A used snap ring may detach from Input Shaft and
result in transmission component damage.
Note: The snap ring will not install if Input Shaft is not
fully seated into Input Shaft Bearing.