8
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Oil Drain Procedure | Removal TRSM0950
Procedure – Oil Drain
1. Locate the Oil Drain Plug on the back of the rear hous-
ing.
2. Place a suitable container under the Oil Drain Plug.
Note: If reusing oil, use a clean container free of con-
tamination and debris.
3. Remove the Oil Drain Plug with a 6 mm hex key and
drain the oil.
4. If PTO-equipped, remove PTO and drain the oil.
5. Inspect Oil Drain Plug and O-ring for damage. If dam-
aged, replace the Oil Drain Plug, O-ring is serviced with
plug.
6. Install the Oil Drain Plug and torque to 24.5-29.5 Nm
(18-22 lb-ft).
NOTICE: Do not over-torque drain plug or transmission
damage may occur.
To Next Page
Loading...
