108
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure - Disassembly
1. Perform “Fluid Pressure Sensor (FPS) Removal” on
page 21.
2. Place Main Housing vertically on a bench with the Main
and Clutch Housing mating surface down.
CAUTION: Main Housing weighs approximately 50 lbs.
Keep fingers clear of pinch point between Main Hous-
ing and other surfaces. Dropping Main Housing could
result in component damage and/or personal injury.
3. Remove Lower Reverse Idler Gear Shaft from Main
Housing by pushing shaft up.
4. Remove Lower Reverse Idler Gear, washers, and bear-
ing from Main Housing.
5. Remove Upper Reverse Idler Gear Shaft from Main
Housing by pushing shaft up.
To Next Page
Loading...
