2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
155
TRSM0950 Installation | Mechatronic Transmission Module (MTM) Installation
12. Verify Rail E is in neutral using the Gear Side Actuator
end of the Confirm-Neutral Gauge (RR1088TR-2) at
Shift Rail E. Rail E is in neutral when end of gauge rests
against housing with rail against notch-end of gauge.
13. Move Shift Rail B in the MTM to neutral. Rail B is in
neutral when the ball detent is in the notch of the Rail B
yoke assembly.
14. Move Shift Rails C and D in the MTM to neutral. Rails C
and D are in neutral when the shift inter-lock is aligned
with the notches of the rail yoke assemblies.
To Next Page
Loading...
