2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
157
TRSM0950 Installation | Mechatronic Transmission Module (MTM) Installation
19. Apply Gasket Sealant to the transmission housing seal-
ing surface following the pattern below.
NOTICE: Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
20. Install MTM onto the transmission housing. Align Rail
E in the MTM with the Rail E Shift Rail in the Main
Housing.
CAUTION: MTM weighs approximately 40 lbs. Keep
fingers clear of pinch point between MTM and other
surfaces. Dropping MTM could result in component
damage and/or personal injury.
NOTICE: If the MTM is installed on the transmission
and Rail E in the MTM is not aligned with Rail E in the
Main Housing, Fault Code 320 (SPN 5942) sets Active
and the transmission will not shift out of neutral.
21. Install 20 MTM cap screws and torque to 44.5-51.5
Nm (33-38 lb-ft) in a criss-cross pattern.
Note: 13 mm (x18), 15 mm (x2) cap screws.
22. Connect the Output Speed Sensor to the connector on
the MTM and close the latch.
To Next Page
Loading...
