212
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Transmission Installation | Installation TRSM0950
Procedure – Installation
1. Push the upper end of the Release Yoke back until it
locks to reset the Linear Clutch Actuator (LCA).
2. Refer to OEM guidelines for transmission installation.
3. Perform “Oil Fill Procedure” on page 213.
4. Key on with engine running.
5. Allow air pressure to build to governor cut-off.
6. Connect ServiceRanger.
7. Go To “Service Routines”.
Note: Complete all Service Routines or transmission
performance will be degraded.
8. Select “Start” Clutch Calibration and follow on-screen
prompts.
9. Select “Start” Rail Calibration and follow on-screen
prompts.
To Next Page
Loading...
