214
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Oil Fill Procedure | Installation TRSM0950
Procedure – Oil Fill
1. Remove the Oil Fill Plug with a 6 mm hex key.
2. Place a suitable container under the Oil Check Plug and
remove the Oil Check Plug with a 6 mm hex key.
3. Fill the transmission with PS-386 lube until a small
amount of oil runs out of the Oil Check Plug hole.
Note: Fill capacity is approximately 7.5-8.5 liters
(16-18 pints) depending on the transmission angle.
4. Inspect Oil Check Plug and O-ring for damage. If dam-
aged, replace the Oil Check Plug; O-ring is serviced
with plug.
5. Install the Oil Check Plug and torque to 24.5-29.5 Nm
(18-22 lb-ft).
NOTICE: Do not over-torque the Oil Fill Plug or trans-
mission damage may occur.
To Next Page
Loading...
