28
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Mechatronic Transmission Module (MTM) Removal | Removal TRSM0950
Procedure – Removal
1. Perform “Oil Drain Procedure” on page 7.
2. Perform “Transmission Removal” on page 17.
3. Perform “Release Bearing and Clutch Release Yoke
Removal” on page 31.
4. Perform “Transmission Control Module (TCM)
Removal” on page 13.
5. Lift the latch on the Output Speed Sensor Harness at
the Connector on the Mechatronic Transmission Mod
-
ule (MTM).
6. Remove the Output Speed Sensor Harness from the
Connector on the MTM.
7. Remove the 20 MTM cap screws.
Note: 13 mm (x18), 15 mm (x2).
To Next Page
Loading...
