32
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Release Bearing and Clutch Release Yoke Removal | Removal TRSM0950
Procedure – Removal
1. Perform “Transmission Removal” on page 17.
2. Remove the Release Bearing by sliding the bearing off
the input shaft.
3. Pull to free the lower Clutch Release Yoke socket from
the lower pivot on the clutch housing.
4. Pull to free the upper Clutch Release Yoke socket from
the Linear Clutch Actuator (LCA) rod end.
To Next Page
Loading...
