44
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Output Yoke Removal | Removal TRSM0950
Procedure – Removal
Note: Output Yoke is removable with transmission in chas-
sis.
1. Remove the driveline. Refer to OEM guidelines for
driveline removal.
2. Remove the 27 mm Retainer Bolt and Retainer Plate.
WARNING: A new Retainer Bolt is required during Out-
put Yoke installation. Failure to replace the Retainer
Bolt may cause a re-used Retainer Bolt to loosen
during operation and may result in major vehicle com
-
ponent damage, severe injury or death.
3. Remove the Output Yoke.
Note: There is an interference fit between the Output
Yoke and output shaft splines that may require an out
-
put yoke puller.
To Next Page
Loading...
