58
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Oil Pump Removal | Removal TRSM0950
Procedure - Removal
1. Perform “Transmission Removal” on page 17.
2. Perform “Transmission Control Module (TCM)
Removal” on page 13.
3. Perform “Release Bearing and Clutch Release Yoke
Removal” on page 31.
4. Perform “Mechatronic Transmission Module (MTM)
Removal” on page 27.
5. Perform “Output Speed Sensor Removal” on page 23.
6. Perform “Harness Bracket Removal” on page 49.
7. Perform “Output Yoke Removal” on page 43.
8. Perform “Rear Housing Assembly Removal” on
page 51.
9. Remove 18 Oil Pump Assembly 13 mm cap screws.
10. Remove Oil Pump Assembly.
11. Remove Oil Pump/Range Spacer with O-ring.
To Next Page
Loading...
