82
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Pilot Bearing Wear Sleeve Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure – Disassembly
1. Perform “Transmission Removal” on page 17.
2. Remove the Spiral Snap Ring from the input shaft with
a pick.
3. Install the Input Shaft Pilot Bearing Wear Sleeve Puller
(RR1062TR) over the flats on the Pilot Bearing Wear
Sleeve.
To Next Page
Loading...
