88
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Cover Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure – Disassembly
1. Remove the Input Shaft Cover O-ring.
2. Place the Input Shaft Cover into a vice equipped with
soft-faced jaw pads with the drain back port at the 8
o'clock position.
Note: Do not over-tighten the vice jaws.
3. Place a lint free cloth over the Input Shaft Cover.
4. Using two pry bars, lift under the Input Shaft Seal at
the 12 o'clock position and remove the Input Shaft Seal
from the Input Shaft Cover.
To Next Page
Loading...
