73
HARDWARE INSTALLATION
Unpack the device very carefully and place it on a flat and firm surface, before
proceeding to connect the accessories
The software must be correctly installed before to install the hardware
ASSEMBLY OF THE RECEIVER BAR
WARNINGS:
Make sure you have a Phillips screwdriver for the screws before mounting.
Confirm that the VESA mount of the monitor is suitable for installation (75mmx75mm
or 100mm x100mm)
Prepare at least four 8 mm diameter screws (not supplied).
Be sure to use the screws and fasteners provided following the instructions described
below correctly.
Do not attempt to install the "T" bar mounting bracket if the monitor is mounted to the
wall using a VESA wall mount.
Be sure to tighten the screws, nuts in the corresponding position otherwise the bar
and / or the monitor could be damaged.
The bar of ultrasound receivers should be placed on the monitor where the visual
stimuli are generated (See Requirements of the visual stimulus monitor)
If you have any doubt, it is better to have a professional to assemble the bar (a
distributor or an authorized technician).
Procedure:
1) Fix part A to part B with 2 screws (M8), place washer and nut and adjust
them smoothly (Figure 1)
2) Fix the bar on the part B by means of 2 screws (M8) place the washer and
nut adjust them smoothly (Figure 1)
3) Present the entire system on the monitor and fit piece A to the monitor with 4
screws (not provided) (Figure 2)
4) If necessary, move the piece B upwards / downwards or move the bar
backwards / forwards until it is on the edge of the monitor screen.
5) When the bar is properly placed. Tighten all screws well (Figure 3)
To Next Page
Loading...
