C3A, C6A, C6A HDVideoColposcope User ManualBasic Operations
- 22 -
3.3.2 Adjusting the Camera Stand Height
You can adjust the camera stand height by adjusting the swing arm. Follow the instructions:
To decrease the height: Hold the swing arm with your hand and press it down to the desired
height, then release your hand.
To increase the height: Hold the swing arm with your hand and lift it up to the desired height,
then release your hand.
Figure 3-4
Due to the locking force of the gas spring inside the swing arm, the swing arm can fix at the
position after you release your hand. The adjustment hole of the gas spring is in the swing arm
axle connecting horizontal arm-2, as shown in the following figure:
Figure 3-5
Press down to
decrease the height
Lift up to increase
the height
To Next Page
Loading...
