EDAN C3A - Setting the Foot Switch; Setting the Camera Handle Trigger; Setting the Video Capture Card

C3A, C6A, C6A HDVideoColposcope User ManualApplication of the Video Colposcope Software
- 80 -
5.12.2.3 Setting the Foot Switch
The foot switch can be used to capture images only (the default function) or to freeze and capture
images.
1) Click the Setupbutton to open the Setupinterface.
2) On the General Setup tab, selectCaptureImage Only or Freeze&CaptureImage in the
Foot Pedal Setup area.
3) Click OK.
4) Exit the system and restart the software immediately.
5.12.2.4 Setting the Camera Handle Trigger
The camera handle trigger can be used to capture images (the default function)，control
coordinate display and display6 image.
1) Click the Setupbutton to open the Setupinterface.
2) On the General Setup tab, selectCaptureImage or Display Coordinate in the Camera
Handle Trigger Setup area.
3) Click OK.
4) Exit the system and restart the software immediately.
5.12.2.5 Setting the Video Capture Card
1) Click the Setupbutton to open the Setupinterface.
2) On the General Setup tab, click the Capture Card Setup button. On the displayed page,
set brightness, contrast, hue, or saturation based on actual requirements by inputting a
specific value or dragging the slider. The setting will take effect immediately. (You can
click Restore Factory Config to restore to the default setting.)
3) Click Exit.
NOTE:
You can open the capture card setup page only after the camera is connected to the
computer and switched on.