C3A, C6A, C6A HDVideoColposcope User ManualBasic Operations
- 23 -
If the swing arm continues to fall after you release your hand, it indicates that the locking force of
the gas spring is too small. You can use a 4 mm socket head wrench to rotate the adjustment hole
of the gas spring to the "+" direction.
If the swing arm continues to rise after you release your hand, it indicates that the locking force
of the gas spring is too large. You can use a 4 mm socket head wrench to rotate the adjustment
hole of the gas spring to the "-" direction.
3.3.3 Adjusting the Camera Angle
The swing arm stand allows flexible adjustment of the camera angle.
Figure 3-6
You can adjust the angle at points A, B and C. Follow the instructions:
Point A: Hold horizontal arm-2 with one hand, and rotate the swing arm to the desired
position on the horizontal direction with the other hand.
Point B: Hold the swing arm with one hand, and rotate horizontal arm-1 to the desired
position with the other hand.
Point C: Hold horizontal arm-1 with one hand, and rotate the holder post to the desired
position by rotating the camera handle with the other hand.
You can also adjust the camera angle by using the horizontal angle adjustment knob and vertical
angle adjustment knob. The operation is the same as that for adjusting the angle of the camera on
the vertical stand, for details, see section 3.2.3Adjusting the Camera Angle.
CAUTION
Do not rotate the camera handle towards the same direction for multiple circles,
otherwise the camera output cable may be twisted or broken.
To Next Page
Loading...
Need help?
General
