C3A, C6A, C6A HDVideoColposcope User ManualApplication of the Video Colposcope Software
- 41 -
Figure 5-13
Click theFollow-uptag, the follow-up patients to be processed in or before the specified
follow-up period will be displayed. The list shows the patients by follow-up date in ascending
order, and the Follow-up tag shows the total number of records. For setting of the follow-up
period, see section 5.12.2.2Setting Follow-up Period.
Select a patient in the list, her information will be displayed in the area above. You can modify
the follow-up status, follow-up date, or remark, and click Save. The inputted follow-up date
cannot be earlier than the current day. If the follow-up status is changed to Cancelled, the
follow-up visit will be cancelled for the patient; if changed toTo Appointment, the system will
make the appointment for the patient, and the Appointment interface shows this appointment
record, in which the appointment time is the follow-up date.
Input search conditions in the Search area, and click Search, all the patients that meet the
conditions will be displayed in the follow-up list. Click Refresh, the original follow-up list is
shown again.
Click Cancel All, the follow-up status of all the patients whose follow-up date has expired will be
set to Cancelled.
NOTE:
You cannot modify information of the patients whose follow-up status is "To
Appointment".
5.3.12 Bar Code Scanner Function
When the bar code scanner is connected to the system, you can activatethe scanner function and
enter patient information by scanning patient bar code.
After thebar code scanner function is enabled (System Setup>General
Setup>ScannerSetup>On), you can scan the patient bar code on the Patientinterface or
To Next Page
Loading...
