C3A, C6A, C6A HDVideoColposcope User ManualApplication of the Video Colposcope Software
- 84 -
2) On the General Setuptab,selectImage Capture Prompts in the Image Capture Setup
area.
3) Click OK.
4) Exit the system and restart the software immediately.
NOTE:
Image Capture Prompts is selected by default. You can deselect it to disable
examination prompts.
5.12.2.16 Enabling Auto Capture
1) Click the Setupbutton to open the Setupinterface.
2) On the General Setuptab,selectAuto Capturein the Image Capture Setup area.
3) Click OK.
4) Exit the system and restart the software immediately.
You can also click the Auto Capture tag on the Examine interface to enable or disable auto
capture.
5.12.2.17 Setting Capture Mode
Two modes are available: screening (the default mode) and diagnose. The system provides more
image capture prompts (if enabled) and captures more images with the auto capture function (if
enabled) in diagnose mode than in screening mode.
1) Click the Setupbutton to open the Setupinterface.
2) On the General Setuptab,select a modeunderCapture Mode.
3) Click OK.
4) Exit the system and restart the software immediately.
5.12.2.18 Restoring to Factory Configuration
On the General Setup tab, clickRestore Factory Config. Except the date format, capture card
and database header, other items on the General Setup tab will be restored to the default settings.
5.12.2.19 Setting Bar Code Scanner
1) Click the Setupbutton to open the Setupinterface.
To Next Page
Loading...
Need help?
General
