EDAN DUS 60 - Page 53

DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual Obstetric Measurements and Calculations
- 96 -
3. Measure Umb A, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. To begin a new Umb A measurement, repeat steps 1 through 3. You can measure a maximum
of one group of data.
7.2.2. MCA
To measure MCA :
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, select MCA.
3. Measure MCA, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. To begin a new MCA measurement, repeat steps 1 through 3. You can measure a maximum
of one group of data.
7.2.3. Fetal AO
To measure Fetal AO:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, select Fetal AO.
3. Measure Fetal AO, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. To begin a new Fetal AO measurement, repeat steps 1 through 3. You can measure a
maximum of one group of data.
DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual Obstetric Measurements and Calculations
- 97 -
7.2.4. Desc.AO
To measure Desc. AO:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, select Desc. AO.
3. Measure Desc. AO, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. To begin a new Desc. AO measurement, repeat steps 1 through 3. You can measure a
maximum of one group of data.
7.2.5. Placent A
To measure Placent A:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, select Placent A.
3. Measure Placent A, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. To begin a new Placent A measurement, repeat steps 1 through 3. You can measure a
maximum of one group of data.
7.2.6. Ductus V
To measure Desc. AO:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, select Desc. AO.
3. Measure Desc. AO, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.