M3A Vital Signs Monitor User Manual Installation of Monitor
- 12 -
NOTE:
1 During POST, make sure all the seven segments are bright, which indicates the seven
segments function well.
2 Check all the functions of the monitor and make sure that the monitor is in good
condition.
3 If rechargeable batteries are provided, recharge them after using the monitor every
time to ensure the electric power is enough.
4 After long-time continuous running, please restart the monitor to ensure the monitor’s
steady performance and long lifespan.
5 If the system is not used for a longer period of time, its system time may be inaccurate.
In this case, reset the system time after powering on.
6 If the system time cannot be saved and resumes the default value after restart, contact
the service department of EDAN to replace the button cell in main board.
2.4 Connecting Sensor to Patient
Connect all the necessary patient sensors between the monitor and the patient.
NOTE:
For information on correct connection, refer to related chapters.
To Next Page
Loading...
Need help?
General
