EDAN M3A User Manual

M3A Vital Signs Monitor User Manual TEMP Monitoring (Optional)
- 76 -
Oral and Axillary temperature taking. The Red probe and Red isolation chamber
must only be used for Rectal temperature taking.
2 Do not attach a Red probe to a Blue isolation chamber or vice-versa.
1. To remove or replace any isolation chamber/probe assembly, grasp the isolation chamber
from each side as shown.
2. Squeeze inward releasing the snaps and slide the isolation chamber up to pull off.
3. To replace, align probe well finger with opening in the top of the unit.
4. Slide the isolation chamber down until the side snaps “click” into place.
5. The probe is connected to the thermometer automatically.
6. To change probes, remove the isolation chamber as described previously.
7. Grasp the sides of the L-shaped connector piece with one hand and then using other hand
pull backward on the latch holding the end of the L-shaped connector.
8. Once free of the latch, slide the L-shaped connector out of isolation chamber.
9. To replace, properly align the top of the L-shaped connector to the slot on the back of the
isolation chamber.
10. Then slide the connector up into the slot pressing firmly on the bottom of the connector until
it “clicks” into place.
10.3.5 Measuring Mode
Predictive Mode
When Mode is set to Predict, the monitor operates in Predictive Mode to provide fast and
accurate temperature measurements.
Quick Predictive Mode
When Mode is set to Quick Predict, the monitor operates in Quick Predictive Mode which is an
oral predictive measurement mode intended for situations where fast temperature measurements
are desired.
Quick Predictive Mode allows clinicians to rapidly identify patients with “normal” body
temperatures. If the patient temperature is outside of the “normal” range, the monitor will
automatically switch into its standard predictive mode to provide a more accurate reading.
Quick Predictive Mode is not available when in Cold Mode.
Monitoring Mode
When Mode is set to Monitor, the monitor will perform continual temperature measurement for
a maximum of 5 minutes.
Besides, in the following instances, the monitor will automatically switch to Monitoring Mode
and perform temperature measurement for a maximum of 5 minutes until the temperature

EDAN M3A Specifications

General

Type	Vital Signs Monitor
SpO2 Measurement Range	0-100%
Parameters	SpO2, Pulse Rate, Temperature
Pulse Rate Measurement Range	30 to 250 bpm
Temperature Measurement Range	0 to 50°C
Power Supply	AC 100-240V, 50/60Hz
Battery Life	Up to 8 hours