EDAN M3A - Chapter 5 Alarm; 5.1 Alarm Modes

M3A Vital Signs Monitor User Manual System Menu
- 27 -
Chapter 4 System Menu
The monitor features in flexible configurations. You can configure various aspects of the monitor,
including the parameters to be monitored, audio signal volume, and output content.
Press the MENU button on the front panel to open Main Menu. You can perform the following
operations in this menu.
4.1 Patient Setup
Click on Patient Setup in Main Menu to open the menu.
You can set the following patient information:
 Patient ID: you can set the patient ID to 1 ~ 200.
 Patient Type: you can set the patient type to Adult, Pediatry or Neonate.
Press the UP/DOWN button on front panel to select the items, and then press the OK button to
confirm.
Select Exit to return to the previous menu.
4.2 NIBP Setup
Please refer to 9.3 NIBP Setup for more information.
4.3 SpO
2
Setup
Please refer to 8.8 SpO
2
Setup for more information.
4.4 TEMP Setup
Please refer to 10.1.3 or 10.2.3 TEMP Setup for more information.
4.5 Alarm Setup
Refer to 5.1.3 Alarm Setup.
4.6 Data Management
Select Data Management in Main Menu to open the menu.
 Start Data Transmission: select this item to start transmitting data from monitor to data
management software.
 Clear Trend List-Clear Current ID: Select this item to clear current ID.
 Clear Trend List-Clear All ID: select this item to clear all ID.