M3A Vital Signs Monitor User Manual Other Functions
- 82 -
Chapter 11 Other Functions
11.1 Nurse Call
The monitor provides dedicated nurse call port which is connected to nurse call system through
the nurse call cable to perform the nurse call function.
NOTE:
Before using the function of nurse call, check if it is functioning normally.
11.2 Network
The monitor can be connected with PC through network port. Our company arranges the qualified
engineers to install and set the wired network for the user and test the corresponding performance.
NOTE:
If signal is unstable, the signal transmission may be degraded.
11.3 Central Monitoring System
The monitor can be connected to the central monitoring system. Through the network:
1. The monitor sends patient information, real-time monitoring or measurement data to the
central monitoring system.
2. The real-time monitoring information is displayed on the central monitoring system as the
same to the monitor, and the central monitoring system can perform some bilateral control.
For example: changing patient information, receiving patient, discharging patient and so
forth.
3. The alarm information of bed side monitor is displayed on the central monitoring system For
example: audio alarm paused, audio alarm off and physiological alarm status and so on.
For detailed information, please refer to MFM-CMS Central Monitoring System User Manual.
NOTE:
When deploying the network of the monitor and MFM-CMS, it is recommended to isolate
the network and the Intranet system of the hospital by using VLAN so as to ensure the
network security.
To Next Page
Loading...
Need help?
General
