EDAN M3A - 7.6 Cleaning Battery and Compartment

M3A Vital Signs Monitor User Manual Trend and Recording
- 42 -
2 Do not leave the recorder door open unless when replacing paper or removing fault.
Removing Paper Jam
If the recorder works improperly or produces unusual sound, open the recorder door and check
whether there is a paper jam. If yes, remove it following the procedure below:
1. Cut the paper from the feeding edge.
2. Open the recorder door.
3. Reload the paper and close the recorder door.
6.3.2 Outputing the Monitoring Data
By selecting the items on Main Menu > Recorder, you can output the real time data, trend graph
current trend table and history trend table.
 Record Realtime Data: Select this item, and the recorder will output the real time data
including measurements and SpO
2
waveforms.
 Record Trend Graph: Select this item, and the recorder will output the trend graph.
 Record Current Trend Table: Select this item, and the recorder will output the current
trend table.
 Record History Trend Table: Select this item, and the recorder will output the history trend
table.
Press the buttom UP or DOWN on the front panel to select an item among the above-mentioned
items from the menu, and press on the front panel to confirm it. Subsequently, the
recorder will start outputting the monitoring data. Meanwhile, the selected item will be changed
into Stop Record.
You can stop the current recording process by select Stop Record on the menu.
NOTE:
Do not use the recording function when a low battery alarm occurs, or automatic
shutdown of the monitor may result.
6.3.3 Recorder Alarm Information
Technical Alarm:
Message
Cause
Alarm Level
What to do
Recorder Out Of
Paper
Recorder Out Of Paper
Low
Please install the paper.
No Recorder
The user presses the
RECORD button when
Recorder is not
configured.
Low
Notify the manufacturer’s
service staff to install and
set the recorder.