Chapter 50
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 1131 –
neighbor route-map This command specifies the route mapping policy for inbound/outbound routing
updates for specified neighbors. Use the no form to remove this policy binding.
Syntax
neighbor {ip-address | group-name} route-map map-name {in | out}
no neighbor {ip-address | group-name} route-map {in | out}
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring routers
configured with the neighbor peer-group command.
map-name – Name of the route map. The route map can be used to filter
the networks to advertise or receive based on various attributes.
(Range: 1-128 characters)
in – Filter inbound routing updates.
out – Filter outbound routing updates.
Command Mode
Router Configuration
Default Setting
No route maps are configured nor bound to any neighbor.
Command Usage
â—† First, use route-map command to create a route map, and the match and set
commands to configure the route attributes to act upon. Then use this
command to specify neighbors to which the route map is applied.
â—† If the specified route map does not exist, all input/output route updates will be
filtered.
Example
Console(config-router)#neighbor 10.1.1.64 route-map RD in
Console(config-router)#
neighbor
route-reflector-client
This command configures this router as a route reflector and the specified neighbor
as its client. Use the no form to disable route reflection for the specified neighbor.
Syntax
[no] neighbor {ip-address | group-name} route-reflector-client
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring routers
configured with the neighbor peer-group command.
To Next Page
Loading...
Need help?
General