Edge-Core ECS4620-28P - Page 729

Chapter 24 | Multicast Filtering Commands
MVR for IPv4
– 729 –
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR
must be configured for an IGMP version 1 host, the multicast groups must be
statically assigned using the mvr vlan group command.
Example
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
mvr associated-profile This command binds the MVR group addresses specified in a profile to an MVR
domain. Use the no form of this command to remove the binding.
Syntax
[no] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Example
The following an MVR group address profile to domain 1:
Console(config)#mvr domain 1 associated-profile rd
Console(config)#
Related Commands
mvr profile (731)
mvr domain This command enables Multicast VLAN Registration (MVR) for a specific domain.
Use the no form of this command to disable MVR for a domain.
Syntax
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)