Edimax BR-6475nD - AP Bridge-Point to Point

91
3‐5‐1‐3APBridge—PointtoPoint

“APBridge—PointtoPoint”modeconnectsthisroutertoanotherrouter andallowsall
thecomputersconnectedtotheLANportsofbothrouterstocommunicatewitheach
other.
Pleasenotethatwhenyouselectthismode,thisbroadbandrouterwillact
asawireless
bridgeonly.Itwillnotacceptotherwirelessclients.Ifyouwishtousethisfunctionwitha
wirelessaccesspointthatsupportsWDS,pleaseselect“APBridge—WDS”mode.



ItemName Description
Band Selectfro moneofthefollowingoptions:

5GHz(A):Allows802.11awirelessnetworkclientsto
connecttothisrouter.

5GHz(N):Allows802.11nwirelessnetworkclientsto
connecttothisrouter(maximumtransferrate
300Mbps).

5GHz(A+N):Allows802.11aand802.11nwireless
networkclientstoconnecttothisrouter
(recommended).

ChannelNumber Selectachannelfromthedropdownmenu.Both
accesspointsmustusethesamechannel(1to140).
MACAddress1 InputtheMACaddressofthewirelessaccesspoint
withwhichyouwishtoconnect.
WirelessModule Select“Enable”toturnonthe5GHzwirelesssignal
andselect“Disable”toturnitoff. 


