Edimax BR-6475nD - AP Bridge-Point to Multi-Point

93
3‐5‐1‐4APBridge—PointtoMulti‐Point

“APBridge—PointtoMulti‐Point”modeconnectsthisroutertoupto4otherrouters
andallowsthecomputersconnectedtotheLANportsofeveryroutertocommunicatewith
eachother.
Pleasenotethatwhenyouselectthismode,this
broadbandrouterwillactasawireless
bridgeonly.Itwillnotacceptotherwirelessclients.Ifyouwishtousethisfunctionwitha
wirelessaccesspointthatsupportsWDS,pleaseselect“APBridge—WDS”mode.



ItemName Description
Band Selectfro moneofthefollowingoptions:

5GHz(A):Allows802.11awirelessnetworkclientsto
connecttothisrouter.

5GHz(N):Allows802.11nwirelessnetworkclientsto
connecttothisrouter(maximumtransferrate
300Mbps).

5GHz(A+N):Allows802.11aand802.11nwireless
networkclientstoconnecttothisrouter
(recommended).

ChannelNumber Selectachannelfromthedropdownmenu.Allaccess
pointsmustusethesamechannel(1to140).
MACAddress1to4 InputtheMACaddressesofthewirelessaccesspoints 
withwhichyouwishtoconnect.
WirelessModule Select“Enable”toturnonthe5GHzwirelesssignal
andselect“Disable”toturnitoff. 
