Edwards APG200 - Figure 7 9 Way D-Sub Connector with Dual Relays; Figure 8 RJ45 Connector with Setpoint Transistor

To Next Page

To Previous Page

Figure 7 9 way D-sub connector with dual relays

A. Gauge B. Connector

C. Electrical supply D. Voltmeter

A. Gauge B. Connector

C. Electrical supply D. Voltmeter

Figure 8 RJ45 connector with setpoint transistor

A. Gauge B. Connector

C. Electrical supply D. Voltmeter

E. DC relay (oponal) F. Back EMF suppression diode (oponal)

G. Grounding switch (oponal)

A. Gauge B. Connector

C. Electrical supply D. Voltmeter

E. DC relay (oponal) F. Back EMF suppression diode (oponal)

G. Grounding switch (oponal)

Page 21D1G0000880_A

D1G0000880_A - Inst

allaon

Main Page

Table of Contents3
Safety and Compliance6
Definition of Warnings and Cautions6
Safety Symbols7
Introduction8
Description8
Figure 1 General View8
Item Number and Description Matrix9
Figure 2 Item Description Matrix10
Figure 3 Item Number Matrix11
Technical Data12
Operating and Storage Conditions12
Manufacturing Materials12
Performance Data12
Mechanical Data13
Electrical Data14
ID Resistor14
Figure 4 Dimensions (MM)14
Pressure Output Signal15
Setpoint15
Installation17
Unpack and Inspect17
Install the Gauge17
Connect the Gauge18
Connect to the Vacuum System18
Connect to the Electrical Equipment18
Figure 5 Electrical Connectors18
Figure 6 9 Way D-Sub Connector with Setpoint Transistor20
Figure 7 9 Way D-Sub Connector with Dual Relays21
Figure 8 RJ45 Connector with Setpoint Transistor21
Maximum Cable Length22
Figure 9 RJ45 Connector with Dual Relays22
Operation23
LED Indicator23
Pressure Measurement24
APG200 with Log Linear with Pressure Output24
Voltage to Pressure Conversion for APG20024
Figure 10 XM, XMP25
Figure 11 XLC25
Figure 12 "O" Output Curves26
Figure 13 "G" Output Curves26
APG200 with Non-Linear Pressure Output27
Figure 14 Q, LC Variant27
Figure 15 Q, M, MP Variants27
Gas Dependency29
Figure 16 Gas Dependency of APG200 with M, MP Filament/Pressure Characteristic30
Figure 17 Gas Dependency of APG200 with LC Filament/Pressure Characteristic30
Advanced Functions31
Setpoint Adjustment32
Figure 18 Adjustment of APG20032
Operation Errors34
Bakeout35
Maintenance36
Atmosphere and Vacuum Adjustment36
Atmosphere Adjustment36
Vacuum Adjustment36
Remote Adjustment - APG200 with Transistor Setpoint [Blank] Option36
Replace the Gauge Tube37
Figure 19 Replace the Gauge Tube38
Fault Finding39
Disposal41
Spares42
Figure 20 Replacement Tube Spares42
Figure 21 Replacement Electronics Housing42
Accessories43
Service44
Return the Equipment or Components for Service44
Appendix - Multi-Function Button Operation45
Figure 22 Multi-Function Button Operation45

Edwards APG200 - Figure 7 9 Way D-Sub Connector with Dual Relays; Figure 8 RJ45 Connector with Setpoint Transistor

Table of Contents

Related product manuals