Edwards APG200

9. Spares
Order the spar
e parts and accessories from our nearest company or distributor. When
you order, give:
▪ Model and item number of your equipment
▪ Serial number (if any)
▪ Item number and descripon of the part.
Figure 20 Replacement tube spares
Z D 1 G A A
A A A
Filament/pressure range
1 : 1x10 or 5x10 mbar to 1000 mbar (model dependent)
2 : 1x10 or 5x10 mbar to 1000 mbar (model dependent)
3 : 1x10 or 5x10 mbar to 1000 mbar (model dependent)
(Corrosion resistant filament)
(Corrosion resistant filament)
Flange
1 : NW16 flange
2 : NW25 flange
5 : 1/8” NPT (male)
6 : Swagelok 4VCR fitting (female)
7 : Swagelok 8VCR fitting (female)
8 : 1/2” OD tube
9 : DN16 conflat flange
-3 -4
-4
-3 -4
-4
Figure 21 Replacement electronics housing
Z D 1 G A 1 A
Filament/pressure range
1 : 1x10 or 5x10 mbar to 1000 mbar (model dependent)
2 : 1x10 or 5x10 to 1000 mbar (model dependent)
3 : 1 x10 or 5x10 mbar to 1000 mbar (model dependent)
(Corrosion resistant filament)
(Corrosion resistant filament)
Setpoint
0 : Transistor setpoint
2 : 2 solid state relay setpoint
Connector
1 : RJ45 connector
2 : 9 pin D - subminiature (male)
Voltage output
0 : 2.0 V to 9.0 V log linear with pressure
3 : 2.2 V to 8.5 V log linear with pressure
2 : 1.9 V to 10.0 V log linear with pressure
4 : 1.875 V to 8.875 V log linear with pressure
5 : 2.0 to 10.0 V non linear with pressure
-3
-4
-4 -4
-3 -4
07/2021 - ©Edwards Limited
Page 42D1G0000880_A
D1G0000880_A - Spares