12 Installation and Service Guide
Introduction
Use caution with sharp edges
The edges of some E-35A components are sharp.
Electrostatic discharge
When you work with electronic components, electrostatic discharge is a concern since it can destroy circuits, or
damage them, reducing their life span. The area around the printer is most likely not static-free, and electrostatic
discharge could occur.
Do the following to avoid damage due to electrostatic discharge:
• Work on a grounded antistatic mat.
• Wear an antistatic wristband, attached to the same location as the antistatic mat.
• Before you remove an electronic component from the shipping box, touch a metal area of the printer to discharge
static from your body.
• After you remove an electronic component from the shipping box, place it face up on a grounded antistatic surface.
• Leave electronic components in antistatic bags until you are ready to use them.
• Do not walk on carpet or vinyl while carrying an electronic component, unless it is in an antistatic bag.
• If you remove an electronic component from the printer, immediately place it in an antistatic bag.
The power cable
Observe the following guidelines:
• Only use the power cable that shipped with the E-35A or an appropriate replacement power cable. For replacement
parts, see your authorized service support center.
• Before you open the E-35A, unplug the E-35A.
• Keep the power cable away from foot traffic.
• Do not place objects on the power cable.
• Do not plug the E-35A into a 2-hole, ungrounded outlet by means of a 3-prong adapter.
• Do not plug the E-35A into a circuit connected to heating or refrigeration equipment (including a water dispenser).
• Do not plug the E-35A into a switchable outlet.
• Do not pull the cable to unplug the E-35A. Instead, pull the plug.
• Do not tamper with or disable the power cable grounding plug.
• Do not use an extension cord.
To Next Page
Loading...
Need help?
General
