43 Installation and Service Guide
Using the E-35A
To shut down, restart, or reboot the E-35A from the Fiery QuickTouch
Note: Notify the site administrator before you remove the E-35A from the network.
1 Make sure that the E-35A is not receiving, processing, or printing any files.
If Printing appears on the Fiery QuickTouch, the E-35A is processing. You must wait until the system finishes and
reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least 5 seconds after the system reaches Idle before beginning the
shutdown procedure.
2 On the Fiery QuickTouch Home screen, tap the Quick Options menu button.
3 Make a selection:
• To shut down the E-35A, select Shutdown system.
• To reboot the entire system including the operating system, select Reboot system.
• To restart the Fiery system software only, select Restart server.
4 At the confirmation screen, select OK.
Allow the system to shut down and power off or restart.
If you selected Restart server, you may need to wait one minute or more for the server software to restart.
Before accessing internal components, make sure that all cables are disconnected from the back of the E-35A.
To shut down, restart, or reboot from the printer touch panel
Note: Notify the network administrator before you remove the E-35A from the network.
1 Make sure that the E-35A is not receiving, processing, or printing any jobs.
If Printing appears on the touch panel, the E-35A is processing. You must wait until the system finishes and reaches
Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before beginning
the shutdown procedure.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning
the shutdown procedure.
2 Press the Fiery tab.
3 Press Restart Fiery.
4 At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)—Resets the E-35A server software but does not reboot the entire system. Network
access to the E-35A is temporarily interrupted and all currently processing jobs are aborted and may be lost. If you
choose this option, you may need to wait 1 minute or more for the server software to reset.
To Next Page
Loading...
Need help?
General
