Printer Operations
Document ID: OMM-00165 Rev. C Pro 32r Operations Guide 128
6.9.3
Figure 6-31
Loading Media
1. Load media to the air shaft.
2. Load the air shaft to the printer and close the chuck.
3. Place the media on the X axis. You can use the ruler for fine adjustment.
4. Put the air gun in the air inlet. Pump air to hold media steady in place.
5. Take up the media through the pinch roller. Make sure it is straight and
parallel to the media roll.
6. Lead the media to the tension roller, over the print table and the front of the tension roller,
and then between the tension and pinch rollers.
7. Close the pinch roller
.
Figure 6-32
Figure 6-33
To Next Page
Loading...
