Printer Setup
Document ID: OMM-00165 Rev. C Pro 32r Operations Guide 80
5.2.2.1 Addressing Wrinkles
1. Increase carriage height and continue printing. It is not recommended to set the carriage higher than 2 mm.
NOTE: Calibrate the Auto Left – Right feature when working with the wrinkle detector.
2. Cool down the print table.
3. Increase the movement margin to help the print table prevent from heating up.
4. Open the press roller and adjust the media. Close it and resume printing.
5. Change the print table vacuum level.
NOTE: When working with media that tend to wrinkle, give it extra stretch by printing with the wings up.
To Next Page
Loading...
