WARNING: TO REDUCE THE RISK OF INJURY, READ ALL INSTRUCTIONS!
All work on this product (system design, installation, operation, setting, configuration,
and maintenance) must be carried out by qualified personnel. To reduce the risk of
electric shock, do not perform any service other than those specified in the operating
instructions unless qualified to do so.
1. Read all the instructions before installation. For electrical work, follow all local and
national wiring standards, regulations, and these installation instructions.
2. Make sure all equipment is properly grounded. All wiring should be in accordance with
the National Electrical Code (NEC), ANSI/NFPA 70.
3. The system can interconnect with the utility grid only if the utility provider permits.
Consult with the local AHJ (Authority Having Jurisdiction) before installing this product
for any additional regulations and requirements for the immediate area.
4. All warning labels and nameplates on the inverter should be clearly visible and must
not be removed or covered.
5. The installer should consider the safety of future users when choosing the correct
position and location for the GridBOSS as specified in this manual.
6. Keep children from touching or misusing the inverter and relevant systems.
7. Beware! Do not connect any DC connections to the GridBOSS.
DISCLAIMER
EG4
®
reserves the right to make changes to the material herein at any time without notice.
Please refer to www.eg4electronics.com
for the most updated version of our manuals/spec sheets.
WARNING!
Cancer and Reproductive Harm – See www.P65Warnings.ca.gov for more details.
To Next Page
Loading...
