12. CHANGELOG
05-01-25 Published v1.1.7
• Added software limited to 200A in the spec sheet for the internal bus rating.
• Fixed the Eaton main description to list the part number followed by its rating correctly.
• Added FlexBOSS18 as a supported hybrid inverter
• Add additional versions of the anti-twist plate in the main lug area under main breaker install.
• Updated the no grid sell back image on page 39.
• Updated error codes in section 11.2
• Changed communications cable max length to 260 feet (80 meters).
03-07-25 Published v1.1.6
• Changed ambient operating temperature on page 1 to -40°F – 113°F (-40°C – 45°C) on page 1
and on page 10.
• Removed (pending) from FCC Part 15, Class B on page 2.
• Changed small knockout diameter from 0.90 to 1.14 in. on page 8.
• Updated wire size and torque values in section 6.5.
• A note was added to verify that the anti-twist plates are properly installed when adding a main
breaker on page 18.
• Added generator 2-wire start specifications on page 24.
• Updated RSD information to read the external switch must be connected in series on page 29.
• Updated RSD information to state smart ports & backed-up loads are disabled when RSD is
initiated.
• Changed no grid sell-back configuration to include powering non-backup load port on page 36.
• Changed grid relay to open in Off-Grid mode image on page 38.
• Removed Mid Box from the settings area and replaced it with Battery Control on pages 39 – 44.
• Removed Mid Box from the settings area and replaced it with Grid Boss on pages 39 – 44.
• Adjusted smart port configurations to include the “Smart Load Based on” setting on page 42 and
page 52.
• Updated Smart Load End Time description on page 53.
• Updated AC Couple setting descriptions on page 54.
• Changed configuration images to reflect using the working modes area of the Monitor Center.
• Updated error and warning codes in sections 11.2 and 11.3.
• Updated the GridBOSS renders to the all silver chassis.
01-02-25 - Published v1.1.5
• Modified wording in Section 5.5 p.23 Generator Port. Value changed from 3% to 12%.
• Changed the shipping hybrid port breaker to 90A
• Removed requirement for shared battery when using more than one inverter with GridBOSS.
• Added fault and warning codes to section 11.
11-26-24 - Published v1.1.4
• Modified cover image to reflect new coat and logo
11-18-24 - Published v1.1.3
• Modified the relays and jump-over line (cable) in the GridBOSS product overview and
configuration examples diagrams.
• Added steps to replace the internal fuses under section 11.2.
• Changed mounting angle images in section 6.1.
• Changed recommended torque specification for the 30A – 125A breakers.
• Changed Product Overview into a main section and added labeling of chassis features.
To Next Page
Loading...
